La Crosse Technology WS-7215U-IT - Manual (Page 19)

19
4) Screw mounting bracket onto the mounting surface.
Ensure that the screws are flush with the bracket.
5) Insert the remote temperature sensor into the bracket.
B. MOUNTING WITH ADHESIVE TAPE
1) With a nonabrasive solution, clean and dry the back
of the mounting bracket and the mounting surface to
ensure a secure hold. The mounting surface should
be smooth and flat.
2) Remove the protective strip from one side of the
tape.
3) Adhere the tape to the designated area on the back of
the mounting bracket.
4) Remove the protective strip from the other side of the
tape.
5) Position the remote temperature sensor in the desired
location, ensuring that the Wireless Temperature
Station can receive the signal.
Note: The adhesive tape is not intended to be used as a permanent mounting
solution. Only use the adhesive tape while you are positioning the
Wireless
Temperature Station and temperature sensor.
II. THE WIRELESS TEMPERATURE STATION
The Wireless Temperature Station can be mounted in two
ways:
• with the table stand or,
• on the wall with the use of a wall hanging screw (not
included).
A. USING THE TABLE STAND
The Wireless Temperature Station comes with the table
stand already mounted. If you wish to use the table-
stand all that is required is to place the Wireless
Temperature Station in an appropriate location.