Lowrance electronic 5150C - Manual (Page 26)

20
Memory card compartment with a 16 MB MMC card installed.
To remove an MMC
1. Open the card compartment door by unscrewing the thumb screw.
The screw should only be finger tight. If it was over-tightened, use a
thumbnail, a coin or a screwdriver to open the door.
2. Just press a finger against the label of the MMC and drag it from the
slot.
3. Close the compartment door and fasten the thumb screw finger tight.
To add an MMC or SD Card
1. Open the card compartment door.
2. Grasp the bottom of the MMC and push the top of the card into the
slot. Once the card is started, use your fingernails to slide it the rest of
the way to the left, until it is firmly seated in the slot.
3. Close the compartment door and fasten the thumb screw finger tight.
Other Accessories
Cleaning Towel
A lint-free microfiber towel is included for cleaning the unit’s screen.
The towel is highly effective in clearing away water spots, smudges and
finger prints. Just wipe the screen with the dry towel — it's not neces-
sary to moisten the towel with water. If the screen is badly soiled, you
may use water or common window or lens cleaners. However, DO NOT
use polishing compounds or any other abrasive product.
If you lose the towel or wear it out, you can replace it with a similar
microfiber cloth. These are often available where shop towels or auto-
mobile cleaning towels are sold.
Caution:
Cleaning fabrics other than the microfiber towel type may scratch
the screen. Polishing compounds or other abrasive cleaners will
scratch the screen. Damage caused by incorrect cleaning is not cov-
Insert card face up,
this way
Thumb
screw
MMC groove for card removal