LG LENNOX MPB3328CNE - Manual (Page 4)

4 NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
Variable Flame Height Adjustment
( Millivolt Appliances only)
1. All Millivolt appliances are equipped with
a variable gas control valve. Flame height for
these models may be adjusted through a range
between fi xed low and high settings, alternately,
while the appliance is in operation. Adjust
the fl ame height as desired after lighting the
appliance by rotating the variable adjustment
control knob located on the front of the valve
(refer to Figure 3).
2. When lit for the fi rst time, this appliance will
emit a slight odor for an hour or two. This is due
to the “burn-in” of internal paints and lubricants
used in the manufacturing process.
Electronic Appliances -
To light electronic appliances refer to the detailed
lighting instructions found in both English and
French on Pages 20 and 21 of these instruc-
tions respectively. Electronic appliance lighting
instructions may also be found on the pull out
lighting instruction labels attached to the gas
control valve. If your electronic appliance is
equipped with an optional remote wall switch
or remote control kit the appliance main burner
may be turned on and off with the wall switch
or remote control.
If your electronic appliance is not equipped
with a wall switch or remote control, the main
burner must be turned off and on with the gas
control switch. Toggle the switch from ON to
OFF to operate the main burner .
Honeywell Electronic Gas Valve
3. Keep lower control compartment clean by
vacuuming or brushing at least twice a year.
More frequent cleaning may be required due to
excessive lint from carpeting, bedding materials,
etc. It is important that control compartments,
burners and circulating air passageways of the
appliance be kept clean.
4. Always turn off gas to the pilot (millivolt
appliances) before cleaning. Before re-lighting,
refer to the lighting instructions in this manual.
Instructions are also found on a pull-out panel
located on the fl oor of the appliance.
5. Always keep the appliance area clear and
free from combustible materials, gasoline and
other fl ammable liquids.
Figure 2
Figure 3
6. Remember, Millivolt appliances have a
continuous burning pilot fl ame. Exercise cau-
tion when using products with combustible
vapors.
7. Clean the front glass enclosure only when
necessary. Wipe surface with clean, dampened,
soft cloth. Follow with dry, soft towel as desired.
Take care not to scratch the glass surface.
SIT Millivolt Gas Valve
If your millivolt appliance is equipped with an
optional remote wall switch or remote control
kit and the pilot is lit, the appliance main burner
may be turned on and off with the wall switch
or remote control.
HI
L O W HT
PT
HT
PT
PILO
T
PIL
O
T
ON
t i
OFF
Variable Flame Height Adjustment
Manifold Pressure Port
Inlet Pressure Port
Main Gas
Control Knob
Piezo Igniter
IN OUT
Piezo Igniter
Optional Burner ON/OFF Rocker Switch Location
(One of Two Places)
ON/OFF Switch
Electronic
Gas Control
Valve
Inlet
Pressure
Port
Manifold Pressure Port
F
F
O
NI
I
S
P
N
O
L
O R T
N O C
GI N
TI
ER
WARNING
Do not use abrasive cleaners. Never
clean the glass when it is hot.
CAUTION
Do not attempt to touch the front
enclosure glass with your hands
while the fi replace is in use.