Life Fitness Fit-1 - Manual (Page 10)

STEP 9:
FIGURE 9
10
STEP 8:
FIGURE 8
51
18
7
76
78
73
75
3/8 X 4-1/4” (106m) 67
2
7
• Insert one 3-5/16” PIVOT SHAFT (47) into the PEDESTAL (7) as shown in FIGURE 8.
• Assemble four 5 X 8” ROLLER PADS (39) and eight 2-3/8” OD PLASTIC WASHERS (32) to the PEDESTAL (7) using four 1-
1/4” SHAFT COLLARS (51) and two 19-1/4” ROLLER PAD TUBES (18) as shown in FIGURE 9.
39
• Once the 5 X 8” ROLLER PADS (39) are assembled to the PEDESTAL (7), SECURE the 19-1/4” ROLLER PAD TUBES (18)
with the four 5/16 X 1/4” SET SCREWS as shown in FIGURE 9.
59
• SECURELY assemble the PEDESTAL (7) to the BENCH FRAME (2) using two RH CAPS (78), one 3/8 X 4-1/4” BOLT (67), two
3/8” SAE WASHERS (75), two 3/8” RH WASHERS (76) and one 3/8” LOW HEIGHT LOCK NUT (73) as shown in FIGURE 8.
• Insert two 3 X 2” END CAPS (59) into the ends of the PEDESTAL (7) as shown in FIGURE 9.
47
32