Remote control – LG LT1230HR User Manual

Page 15

Advertising
background image

Service Manual 15

Operating Instructions

Remote control

The remote control and control panel will look like one of the following pictures.

Power

Temp

Fan Speed

Timer

Mode

POWER

• To turn the air conditioner ON, push this button.

To turn the air conditioner OFF, push the button again.

• This button takes priority over any other button.

TEMPERATURE SETTING

• Use this button to automatically control the temperature of the room.

The temperature can be set within a range of 60

°

F to 86

°

F by

increments of 1

°

F.

• The setting appears in the display.

FAN SPEED

• Every time you push this button it advances the setting as follows:

{High[ F2 ]

Low[ F1 ]

High[ F2 ]}

TIMER

- SHUT-OFF TIME

• You will usually use shut-off time while you sleep.
• If unit is running, use Timer to set number of hours until shut-off.
• For your sleeping comfort, once Time is set, the Temperature setting will

raise 2

°

F after 30 min, and once again after another 30 min.

• Push Timer button to advance setting from 1Hour

2Hours

...

12Hours maximum.

- START TIME

• If unit is off, use Timer to set of hours before unit starts.
• Push Timer button to advance setting from 1Hour

2Hours

...

12Hours maximum.

MODE

- Push this button to shift mode of operation from COOL

ENERGY SAVER

FAN

Heat.

- COOL:

• Fan runs continually for normal cooling operation.

- ENERGY SAVER:

• The fan stops when the compressor stops cooling. Approximately every 3 minutes the fan will turn on

and the unit will check the room air temperature to determine if cooling is needed.

- FAN:

• Fan-only operation.

- HEAT:

• Fan runs continually for normal heating operation.

When the air conditioner has been performed its cooling or
heating operation and is turned off or set to the fan posi-
tion, wait at least 3 minutes before resetting to the cooling
operation again.

A slight heat odor may come from the unit when
first switching to HEAT after the cooling season is
over. This odor, caused by fine dust particles on
the heater, will disappear quickly. This is harmless.

Advertising