Line 6 3.7 - Manual (Page 17)

Line 6 GearBox 3.7 – Using Your Line 6 Hardware
2•10
Main Outputs 1-2 are controlled by a main volume knob and main mute button. The volume knob
is an analog level control and does not affect any level being sent to your computer. When Mute is
engaged, as solid amber LED illuminates, blinking about once every 2 seconds.
Note that these controls operate on main outputs 1-2 only (headphone and S/PDIF levels are not
affected). Outputs 3 – 8 are software controlled.
Headphone Output Controls
Headphone outputs 1-2 and 3-4 provide duplicate stereo outputs or Main Outs 1-2 and 3-4 respectively,
providing discrete control over output levels sent over the headphone jacks. Note that headphone
output levels are controlled independently of the Main volume control.
Power Button
When the power button is engaged*, the TonePort UX8’s main LEDs will illuminate. TonePort UX8
is not USB powered and receives no power from the computer.
*Note - Be sure to always power off or mute your speakers or monitoring setup before powering your
TonePort on/off, as well as before booting up or shutting down your computer if TonePort is already
connected. The best practice is to always power on your speakers last, and power them off first when
connected to other audio gear to avoid a “pop”.
LED status indicators
The Main Mute and Main Clip LEDs provide secondary functions in their ability to indicate the
connection status of USB and S/PDIF, as follows:
No USB connection - The main clip LEDs alternate steadily between left and right, about once •
every second. The USB cable may be unplugged or the UX8 driver may not be installed on your
computer.
No S/PDIF clock sync - • The Mute LED blinks 3 times rapidly about once every second
when the clock mode set to S/PDIF, and no external clock is present.