Taking pictures using burst mode – Panasonic DMC-LC70PP User Manual
Page 46
Recording pictures (basic)
46
Taking Pictures using Burst Mode
Preparation
• Set the mode dial except for [
]/[
]. (P29)
1
Switch the burst mode setting.
: High speed
;
: Low speed
;
No display (canceled)
2
Take pictures.
• Keep pressing the shutter button
fully to activate the burst mode.
¬Suggestions/Tips ¬
• If the flash is activated, you can record
only 1 picture.
• In Simple mode [
], the burst speed
is fixed to Low. (P34)
• You cannot take pictures with audio in
the burst mode.
• When setting auto bracket and the
burst mode simultaneously, auto
bracket will be performed.
• Burst mode will not perform as
described if a MultiMediaCard is used
in place of an SD Memory Card. The
reading/writing speed of a
MultiMediaCard is slower than that of
an SD Memory Card.
• In the following cases, the burst speed
becomes slow due to the signal
processing, however, this is not a
malfunction of the camera.
(a) When you take pictures in a dark
place.
(b) When you use the camera in high
temperature locations.
The number of pictures taken at a time
is not limited in the above cases.
• When the ISO sensitivity is set to
[ISO400], you cannot use the burst
mode. (DMC-LC80)
ª Number of pictures recorded in
burst mode
°1 When the shutter speed is
faster than 1/60 and the flash is
not activated.
°2 2304k1728 picture size
°3 2048k1536
picture size
H
1600
19
H
L
Burst speed
(pictures/
second)
Number of
recordable
pictures (pictures)
DMC-
LC80
2.7
(
°1
)
1.5
max. 5
max. 9
DMC-
LC70
3.3
(
°1
)
2
max. 3
(
°2
)
/
max. 5
max. 5
(
°2
) /
max. 10
DMC-
LC50
3.5
(
°1
)
2
max. 5
max. 8
(
°3
)
/
max. 10
H
L
DMC-LC80.book 46 ページ ２００４年６月１５日 火曜日 午後５時４９分