Polycom TransTalk 9000-Series - Manual (Page 159)

Call Coverage (F20,XX,XX)—Release 2.0 or Later
5-49
To send calls for coverage using the programmed button:
1. Press the programmed button.
If an originating extension and a covering extension were programmed on
the button, Call Coverage is activated (on a button with lights, the green
light is on). Skip Steps 2 and 3.
2. If no originating extension was programmed, dial your extension number.
3. If no covering extension was programmed, dial the extension number of the
covering extension.
Call Coverage is activated (on a button with lights, the green light is on).
To remove Call Coverage using the programmed button:
1. Press the programmed button.
If an originating extension and a covering extension were programmed on
the button, Call Coverage is deactivated (on a button with lights, the green
light is off). Skip Steps 2 and 3.
2. If no originating extension was programmed, dial your extension number.
3. If no covering extension was programmed, dial your extension number
again.
Call Coverage is deactivated (on a button with lights, the green light is off).
Standard Phone
To send your calls for coverage:
1. Lift the handset.
You hear intercom dial tone.
2. Press # 2 0 .
3. Dial your extension number.
4. Dial the extension number of the covering extension.
To remove Call Coverage:
1. Lift the handset.
You hear intercom dial tone.
2. Press # 2 0 .
3. Dial your extension number twice.