Programming, Using, System phone – Polycom TransTalk 9000-Series User Manual
Page 201: Standard phone
Contact Closure (F41 and F42)
5-91
Programming
(See Figure 2-3 on page 2-22 for the location of special programming buttons such
as
s
and
e
on system phones.)
To program a Contact Closure button:
1. Press
f 0 0 s s c
at extension
10 or 11.
2. Enter the number of the extension to be programmed with this feature.
3. Press a programmable button, preferably one with lights.
4. Press
f 4 1
(for Contact Closure 1) or
f 4 2
(for Contact
Closure 2).
5. Program another button for this extension or exit programming mode.
Using
System Phone
To activate a Contact Closure:
1. Press the programmed button or press
f 4 1
(for Contact Closure
1) or
f 4 2
(for Contact Closure 2).
The green light is on steady.
2. If the Contact Closure Operation Type for that Contact Closure is set to
Toggle, repeat Step 1 to deactivate the Contact Closure.
The green light goes off.
Standard Phone
To activate a Contact Closure:
1. Pick up the handset to get an intercom dial tone.
2. Press
# 4 1
(for Contact Closure 1) or
# 4 2
(for Contact Closure 2).
3. If the Contact Closure Operation Type for that Contact Closure is set to
Toggle, repeat Steps 1 and 2 to deactivate the Contact Closure.