Polycom TransTalk 9000-Series - Manual (Page 229)

Display Language (#303)
5-119
Display Language (#303)
Description
This System Programming procedure identifies the language in which display
messages appear if the extension has a system display phone. The language is
set for each extension, so phones in the same system can display different
languages.
Considerations
If SMDR is used, the call report header is printed in the language specified for
extension 10.
Valid Entries
1 = English
✔
2 = Spanish
3 = French
Programming
(See Figure 2-3 on page 2-22 for the location of special programming buttons such
as
s and e on system phones.)
To change the Display Language setting for an extension:
1. Press f 0 0 s s # 3 0 3 at extension
10 or 11.
2. Enter the number of the extension to be programmed. For example, to
program extension 11, press 1 1 .
The current display language displays.
3. To change the display language, press D until the appropriate value
displays.
4. To change the display language for another extension, press n or
until the extension number shows on the display. Then repeat Step 3.
5. Select another procedure or exit programming mode.