Polycom TransTalk 9000-Series - Manual (Page 233)

Doorphone Alert Extensions (#606)
5-123
Doorphone Alert Extensions (#606)
Description
This System Programming procedure identifies extensions that are signaled when
a doorphone button is pressed. When a person uses the doorphone, it signals all
alert extensions at the same time. If the alert extension is a system phone, the call
signals with a unique
ding-dong sound to distinguish it from other calls.
Additionally, if you have two doorphones, they signal with different tones so you
can distinguish between them.
Related Features
■ You must use Doorphone Extensions (#604 and #605) to identify the
extensions to which doorphones are connected.
■ If Do Not Disturb is active at a doorphone alert extension, the person at
the doorphone hears signaling, but the alert extension is not signaled.
■
If a Contact Closure on the Contact Closure Adjunct controls a door lock,
consider assigning the Doorphone Alert Extensions to the Contact
Closure Group (#612) for that Contact Closure. Only extensions assigned
to that Contact Closure Group can activate the door lock.
Considerations
You cannot bridge two doorphones together.
Valid Entries
1 = Not an Alert Extension ✔
2 = Doorphone 1 Alert Extension
3 = Doorphone 2 Alert Extension
4 = Doorphones 1 and 2 Alert Extension
Programming
(See Figure 2-3 on page 2-22 for the location of special programming buttons such
as
s and e on system phones.)
To identify doorphone alert extensions:
1. Press f 0 0 s s # 6 0 6 at extension
10 or 11.
2. Enter the first alert system extension number. For example, to identify
extension 10, press 1 0 .
3. To change the alert status, press D until the appropriate value
displays.
4. To identify another alert extension, press n or p until the
extension number shows on the display. Then repeat Step 3.
5. Select another procedure or exit programming mode.