Polycom TransTalk 9000-Series - Manual (Page 241)

Extension Name Display
5-131
Programming
(See Figure 2-3 on page 2-22 for the location of special programming buttons such
as
s and e on system phones.)
To assign a name to an extension:
1. Press f 0 0 s s c at extension
10 or 11.
2. Enter the number of the extension to be programmed. For example, to
program extension 12, press 1 2 .
3. Press left i . For extension 12, the display reads:
12 Enter Extension Name
If a name was assigned previously to this extension, that name displays
instead.
4. Enter the two-digit code for each character you want to enter. (See Table
5-3 for codes.) For example, to enter the name Andy, press 21 62
31 93 . The display reads:
12 ANDY
5. If you make a mistake, you can press ! to clear the display. Repeat
Step 4 to enter the correct name.
6. Program a button for this extension or exit programming mode.
Table 5-3. Character Codes
Letters: Numbers:
A = 21 N = 62 blank = 11
B = 22 O = 63 0 = 00
C = 23 P = 71 1 = 10
D = 31 Q = 72 2 = 20
E = 32 R = 73 3 = 30
F = 33 S = 74 4 = 40
G = 41 T = 81 5 = 50
H = 42 U = 82 6 = 60
I = 43 V = 83 7 = 70
J = 51 W = 91 8 = 80
K = 52 X = 92 9 = 90
L = 53 Y = 93
M = 61 Z = 94