Polycom TransTalk 9000-Series - Manual (Page 243)

External Hotline (#311)
5-133
■
A standard phone without a dialpad is recommended for use as the
external hotline.
■ You can identify several extensions as external hotlines.
■ Do not assign an external hotline to extension 10, 11, or to the first two
extensions of any 206 or 308EC modules, which are reserved as power
failure extensions.
Valid Entries
Any extensions except for 10, 11, or the first two extensions of any 206 or 308EC
modules.
1 = Assigned
2 = Not Assigned
✔
Programming
(See Figure 2-3 on page 2-22 for the location of special programming buttons such
as
s and e on system phones.)
To identify an external hotline extension:
1. Press f 0 0 s s # 3 1 1 at extension
10 or 11.
2. At the Extension: prompt, enter the external hotline extension
number— see “Valid Entries” above. For example, to program extension 30
as the external hotline, press
3 0 .
3. To assign or unassign the extension, press D until the appropriate
value displays.
4. To program another extension, press n or p until the
extension number shows on the display. Repeat Step 3.
5. Select another procedure or exit programming mode.
To program the external hotline phone number as Personal Speed Dial code 80:
1. Press f 0 0 s s c .
2. Dial the extension number of the external hotline.
3. Press f 8 0 .
4. Enter the external hotline phone number exactly as you would dial it.
5. Continue programming or exit programming mode.