Polycom TransTalk 9000-Series - Manual (Page 331)

Pool Line Assignment (#207)—Release 2.0 or Later
5-221
Programming
(See Figure 2-3 on page 2-22 for the location of special programming buttons such
as
s and e on system phones.)
To change the assignment of lines to pools:
1. Press f 0 0 s s # 2 0 7 .
2. Enter the first line to be programmed. For example, to program line 8,
press 0 8 . A display similar to the following appears:
Lines to Pools L08
2 Pool 880
3. Enter the desired value (1–5)—see “Valid Entries” on the previous page.
4. To program another line, press n or p until the line number
shows on the display. Then repeat Step 3.
5. Select another procedure or exit programming mode.