Polycom TransTalk 9000-Series - Manual (Page 371)

System Password (#403)
5-261
System Password (#403)
Description
This feature is available only on PARTNER- and MLS-model phones.
This System Programming procedure defines a four-digit password that users can
enter from PARTNER- and MLS-model phones to override dialing restrictions (if
the extension has access to an outside line).
Related Features
■ The password overrides all dialing restrictions except Line Access
Restriction (#302) and Pool Access Restriction (#315).
■ Once a password is programmed, you must enter it to turn Night Service
on and off. Additionally, if Night Service is on, users in the Night Service
Group must enter the password to make any outgoing calls (except calls to
numbers on the Emergency Phone Number List (#406) and Marked
System Speed Dial Numbers). Dialing restrictions for extensions not in
the Night Service Group remain the same as during normal daytime
operation.
Programming
(See Figure 2-3 on page 2-22 for the location of special programming buttons such
as
s and e on system phones.)
To program a System Password:
1. Press f 0 0 s s # 4 0 3 at extension
10 or 11. A display similar to the following appears:
Set System Password
Data - - - - - - - - - - - -
2. Enter a four-digit password or press r to delete the existing
password.
3. Select another procedure or exit programming mode.
Using
1. Before lifting the handset or turning on the speaker at a PARTNER- or
MLS-model phone, press h .
2. Enter the password.
The System Password does not appear on display phones.
3. Press an outside line button (or press i 8 and a two-digit line
number) or a pool button (or press i and a three-digit access code)
and lift the handset.
4. Dial the number.
The password is in effect until you hang up the phone.