Polycom TransTalk 9000-Series - Manual (Page 395)

VMS Hunt Delay (#506)
5-285
Valid Entries
For Release 3.0 or Later:
Mode
1 = Day
2 = Night
Number of Rings
0 - 6
2
✔
Programming
For Release 2.0 or Earlier:
(See Figure 2-3 on page 2-22 for the location of special programming buttons such
as
s and e on system phones.)
To change the VMS Hunt Delay setting for the voice messaging system’s
Automated Attendant service:
1. Press f 0 0 s s # 5 0 6 at extension
10 or 11.
2. Press D until the appropriate value displays.
3. Select another procedure or exit programming mode.
For Release 3.0 or Later:
(See Figure 2-3 on page 2-22 for the location of special programming buttons such
as
s and e on system phones.)
To change the VMS Hunt Delay setting for the voice messaging system’s
Automated Attendant service:
1. Press f 0 0 s s # 5 0 6 at extension
10 or 11.
2. Select Day or Night mode by entering 1 or 2 respectively.
3. Enter the line number.
The current setting displays.
4. To set VMS Hunt Delay, press D until the appropriate value displays.
(See ‘‘Valid Entries’’ above.)
5. To set VMS Hunt Delay for another line, press n or p until the
line number shows on the display. Then repeat Step 4.
6. Select another procedure or exit programming mode.