Polycom TransTalk 9000-Series - Manual (Page 399)

Voice Interrupt On Busy (#312)
5-289
— To resume your conversation with the third party, press the line or
pool button next to the winking green light.
■ Any party involved in a voice interrupt on busy call cannot be involved in a
second voice interrupt on busy call until the first is finished.
■ Cannot be performed on Record-a-Call.
Valid Entries
1 = Assigned
2 = Not Assigned
✔
Programming
(See Figure 2-3 on page 2-22 for the location of special programming buttons such
as
s and e on system phones.)
To change the Voice Interrupt On Busy setting for an extension:
1. Press f 0 0 s s # 3 1 2 at extension
10 or 11.
2. Enter the number of the extension to be programmed with this feature.
3. To assign or unassign Voice Interrupt On Busy, press D until the
appropriate value displays.
4. Select another procedure or exit programming mode.
Using
To initiate a voice interrupt on busy call:
1. From a system phone, press i .
2. Press * plus a two-digit extension number (or use an Auto Dial button).
3. Listen for one of the following responses:
■ If you hear one beep, you have reached an idle system phone. You
can speak after the beep.
Your voice is heard through the other extension’s speaker. If the
recipient is present, he or she can reply.
■ If you hear two beeps, you have reached a busy system phone with
Voice Interrupt On Busy Assigned. You can speak after the beeps.
Be aware that the third party to whom the recipient is speaking
probably also will hear the two beeps and the faint sound of your
voice.
If the recipient has a Voice Interrupt On Busy Talk-Back button, wait
for a response. If you hear a second set of beeps, the recipient has
ended the voice interrupt on busy call. In either case, hang up to end
your part of the voice interrupt on busy call.