Polycom TransTalk 9000-Series - Manual (Page 436)

A-1
Specifications
Capacities
System Module Extension Jack
● 19 outside lines via line jacks on
one ACS processor module plus
four 400 modules
● 40 extensions via extension
jacks on one ACS processor
module plus four 308EC
modules
● 1 loudspeaker paging system
via PAGE jack on ACS
processor module
● 1 audio source via
Music-on-Hold jack on ACS
processor module (RCA phono
plug required)
● 1 call reporting device via
SMDR jack on ACS processor
module (335 A/F adaptor
required)
● 1 Contact Closure Adjunct using
CONTACT CLOSURE jack on
ACS processor module
● 2 doorphones, using two
extension jacks
● 1 voice messaging
system-PARTNER MAIL VS,
which uses a slot in the 2- or 5-
Slot carrier, or PARTNER MAIL,
which connects to either 3, 5, or
7 extension jacks
ACS Process or Module:
● 3 outside lines
● 8 extensions
● 2 touch-tone receivers except
when used with 308EC module
● 2 power-failure transfer
extensions
200 Module:
● 2 outside lines
● 0 extensions
● 1 touch-tone receiver
206 Module:
● 2 outside lines
● 6 extensions
● 1 touch-tone receiver
● 1 power-failure transfer
extension
308EC Module:
● 3 outside lines
● 8 extensions
● 6 touch-tone receivers
● 2 power-failure transfer
extensions
400 Module:
● 4 outside lines
● No extensions
● 2 touch-tone receivers
● Maximum two devices per
extension jack, total REN on
jack not to exceed 2.0 [System
phone REN is 0.0(zero)]
Note: The two devices combined
on an extension jack can be a
system phone with a standard
device, or two standard devices.
DO NOT connect two system
phones to the same extension
jack. If a device lists two RENs,
use the higher number when
adding up the RENs.
● No more than one system
phone per jack
For programming, a system
display phone must be connected
to extension 10 or 11.