Panasonic WV-CM1780 - Manual (Page 13)

13
■ Audio Volume Control
The audio volume can be adjusted with the - or + button in normal view.
While the volume is being adjusted, the indicator displays the changed level as shown below.
- : Decreases the audio volume.
+ : Increases audio volume.
■ Standby Function
1. Power up the monitor and select the input to be displayed.
Refer to Power Up above.
2. Pressing the STANDBY button will toggle the display mode in the sequence shown below.
The Power Indicator changes to orange in the standby mode, and the display shown below will appear on the monitor
screen.
MODE 1: Pictures are displayed with less brightness.
MODE 2: Monitor blackout, i.e., no picture is displayed.
Notes:
• Speaker (audio) output is disabled in the standby mode.
• The Standby mode can be controlled by the input from the STANDBY ON/OFF terminal on the rear of the monitor.
The input signal will toggle the mode selected in the Display Setting menu on and off.
To set up this function, refer to STANDBY ON in the Display Setting menu.
■ To Reset to the Factory Default Settings
If you are not sure about the settings you made and want to return to the factory default settings, follow the procedure shown
below.
1. Turn off the monitor by pressing the POWER button.
2. Turn on the monitor by pressing the POWER button while holding down the MENU and + buttons.
All settings in the Display Setting and the Setup menu are reset to the factory default settings.
AUDIO
Normal Display STANDBY/MODE1 STANDBY/MODE2