Panasonic WV-CM1780 - Manual (Page 14)

14
OPERATING PROCEDURES (with the System Controller)
For the following procedure, the WV-CM2080, WV-CM1780 or WV-CM1480 needs to be set up first from the Setup menu.
The WV-CM2080, WV-CM1780 or WV-CM1480 can be controlled with the specified System Controller.
Given below is an example. For further details refer to the Operating Instructions supplied with the System Controller.
1. Select a Unit Address number by pressing the Numeric buttons, then press the UNIT button.
2. To select the input to be displayed, select a specified CAM NO. (input number assigned) by pressing the Numeric but-
tons, then press the CAM/SET button.
3. To open the Display Setting menu, press the SETUP/FUNCTION button for two seconds or more.
4. Move the cursor to the item parameter by moving the joystick up or down, then select the item parameter by moving the
joystick to the right or left.
5. Pressing the CAM/SET button will switch to the level indicator display, then pressing the MON/ESC button will return to
the menu display.
6. To close the menu, press the SETUP/FUNCTION button for two seconds or more
7. To activate the assigned function, select an assigned number by pressing the Numeric button, then press the SETUP/
FUNCTION button after pressing the SHIFT button.
Note: For function numbers refer to the Appendix on page 16.
OPERATE LOGIN ALARM
CAM SETUP
PROGRAM
PROGRAM
PRESET
UNIT A
IRIS
CLOSE OPEN
NEAR FAR
WIDE TELE
FOCUS
ZOOM
AUTO FOCUS
IRIS RESET
AUTO
SETUP
ALM SUSPEND
FUNCTION CAM FUNCTION
MULTI SCREEN SELECT DEF
WIPER EL-ZOOM
SHIFT
ALM RESET
VCR CAM
STILL
– +
ALM RECALL
PATROL
LEARN
PATROL
STOP
AUX 1
AUX 2
B/W UNIT
SEQ PAUSE
SLOW
SEQUENCE PATROL PLAY HOME/PRESET
UNIT B
MON CAM
LOGOUT ESC SET
UP
L R
DOWN
BUSY PROHIBITED
MONITOR
UNIT
CAMERA
System Controller WV-CU
360