Panasonic CF-W8 - Manual (Page 129)

129
Troubleshooting (Advanced)
Access point is not detected
z Shorten the distance between the computer and the access point, and try the detection again.
z It may take some time before the access point is displayed in [Available Networks]. Wait for a moment.
z Confirm the following settings:
• [Wireless LAN] in the [Advanced] menu of the Setup Utility
Confirm that [Wireless LAN] is set to [Enabled]. ( Î page 100 )
• Wireless device off:
Confirm that / / is displayed on the notification area.
Confirm whether the Intel ® PROSet/Wireless Software is installed using the following menu.
[start] - [Control Panel] - [Add or Remove Programs].
If it has not been installed, input [c:\util\drivers\wlan\WiFi\XP\x32\Install\install.bat] in [start] - [Run] to install.
• Wireless LAN power supply
If is displayed on the notification area, slide the wireless switch to the right (ON).
• IEEE802.11a settings
Even if the wireless LAN is on, IEEE802.11a may be set to disable. If IEEE802.11a is to
be used, change this setting to enable. (
Î page 92 )
z This computer uses channels 1 through 11
*3
when using IEEE802.11b/g. Check the chan-
nel being used by the access point.
*3 In the case of wireless communications, the frequency band being used can be divided into
segments, so that different communications can be conducted on each band segment. A “Channel”
refers to the individual frequency bandwidth divisions.
Problems with Wireless LAN (only for models with wireless LAN)
CF-F8 Series
WIRELESS
CF-W8/CF-T8 Series