Printronix T5000e - Manual (Page 38)

Chapter 2 QUICK SETUP Menu
38
QUICK SETUP Menu
QUICK SETUP
Print Intensity
6 ips* 2-10 ips
1 Print Speed
Print Mode
Paper Feed Shift
Label Width
Label Length
Orientation
Transfer* Direct
4.1, 6.6, or 8.5 inches* 2, 4
Portrait* Landscape Inv. Portrait Inv. Landscape
-3* -15 to 15
00.1 to 8.5 inches 4
0.00 inches* 2
4 or 6 inches* 2, 4 00.1 to 99.0 inches 5
-0.50 to X inches 3
Run Calibrate Auto Calibrate
Ver Image Shift
Hor Image Shift
0.00 inches* 2
-1.00 to 1.00 inches 0.00 inches* 2
-1.00 to X inches 3
Tear-Off Strip* Tear-Off Peel-Off Cut Media Handling Continuous
Gap/Mark Sensor Disable* Mark Gap Advanced Notch Advanced Gap
Notes:
* = Default
1 Maximum value depends on the width of the
printer model and printhead.
2
You can change the unit value from inches to
millimeters under Units (in MEDIA CONTROL)
Refer to the
User’s Manual for information.
3 Based on the current value setting for the Label
Length menu, up to a maximum of 12.80 inches.
4 Maximum value depends on the width of the
printer model.
5 Maximum value depends on model width and size
of DRAM installed.
(cont. on next page)
1* 1-8
Factory* 1-8
Save Config.
Power-Up Config.