Printronix T5000e - Manual (Page 46)

Chapter 2 QUICK SETUP Menu
46
Power-Up Config.
You can specify one of the eight configurations as the power-up
configuration. The default is Factory.
SMT: Status
See “Software Migration Tools (SMT)” on page 65.
• Disabled.The printer disables the use of the Software
Migration Tools.
• Enabled. The printer enables the use of the Software Migration
Tools.
SMT: Sel Toolset
See “Software Migration Tools (SMT)” on page 65.
• Toolset [1]. SMTs for PGL
®
emulation.
• Toolset [2]. SMTs for PPI1 emulation.
• Toolset [3] and Toolset [4]. Reserved for internal use and
future design.
SMT: Select Tool
See “Software Migration Tools (SMT)” on page 65.
• EPC, GTIN, UPCA, EAN8, EAN13, and UCC128. SMTs
displayed if Toolset [1] is selected under SMT: Sel Toolset.
• zEPC, zGTIN, zUPCA, zEAN8, zEAN13, and zUCC128. SMTs
displayed if Toolset [2] is selected under SMT: Sel Toolset.
NOTE: Undocumented options are reserved for internal use and
future design.