Precor Strength-Training S3.25 - Manual (Page 21)

S3.25 Assembly and Maintenance Guide
page 21
1 2 3 4 5 6
10. Assemble Chest Press Seat
A. Place the Backpad and Headrest on the floor. Place
the Long Support Tube and Short Support Tube on
the Backpad. Attach at the top using
two 1¼-inch bolts
two washers
B. Attach at the bottom using
three 3-inch bolts
three washers
C. Attach the Backpad and Headrest assembly to the
Chest Press Upright using
one ½-inch x 5¼-inch bolt
two washers
one locknut
Finger tighten.
Note: The Stop Pad on the seat assembly should
be between the Pop Pin and the Support Stop on
the Chest Press Upright.
D. Wrench tighten, still allowing movement.
CAUTION: If you move the Handlebars out of
the way for this step, be careful that they don’t
hit you.
E. Attach the Seat Pad to the Seat Stem using
two 1¼-inch bolts
two washers
Wrench tighten.
Note: If you have purchased the Leg Press Option,
open the S3.25 Leg Press Option box now and begin
with Step 2.
Step 10. Assemble Chest Press Seat
1
2
3
4
1
2
3
4
Long Support
Tube
Seat Pad
Backpad
1 - ½" x 5¼" bolt
2 - washers
1 - locknut
C
Seat Stem
Short
Support
Tube
2 - 1¼" bolts
2 - washers E
Long Support Tube
Short
Support
Tube
3 - 3" bolts
3 - washers B
2 - 1¼" bolts
2 - washers A
Short Support
Tube
Long
Support
Tube
Backpad
Stop Pad
Pop Pin
Chest Press
Upright
Headrest
Headrest
The Backpad and Headrest are not
shown in this illustration.