Paxar 9430RX - Manual (Page 19)

2-6 Configuring the Printer
ESC Starts the command language.
‘cmdbbw’ Search for black mark backward command.
Enter QB.
<max> The maximum number of lines to move backward
in 0.25mm line increments (in 00 hex – FF hex).
Printer Responses
See the printer’s response to the black mark commands in the following table.
Command Response Description
ESC-'Q'-3F hex-3F hex-#high#-#low# Black mark found. ESC QR39
ESC QB35
ESC-'Q'-30 hex-30 hex-#high#-#low# Black mark not found
#high# The left digit of the hex number representing the
number of lines moved to find the black mark in
30 hex – 3F hex.
#low# The right digit of the hex number representing the
number of lines moved to find the black mark in
30 hex – 3F hex.
C h e c k i n g V e r s i o n I n f o r m a t i o n
You can check the versions of both the printer’s hardware and firmware.
Syntax ESC-‘cmdfv’
ESC-‘cmdhv’
ESC Starts the command language.
‘cmdfv’ Request firmware version command. Enter P(.
ESC Starts the command language.
‘cmdhv’ Request hardware version command. Enter P).