Philips FTR9964/69S - Manual (Page 11)

10
Installation
10
Programme title
&
Select Programme title with the cursor down.
é
Press the cursor right to select Programme title Yes or No .
When selected Yes , after the selection of a TV programme or after pressing
the i key on the remote control, a TV channel which broadcasts teletext
may transmit the name of the TV channel or the programme title.
When selected
No , the programme title will only appear after pressing the
i key, and not after the selection of a TV channel.
Teletext level 2.5
Some broadcasters offer the opportunity to see more colours, other
background colours and nicer pictures in the teletext pages.
&
Select Teletext level 2.5 with the cursor down.
é
Press the cursor right to select Teletext level 2.5 On to take advantage of
this feature.
“
Press the cursor right again to select Teletext level 2.5 Off if you like the
more neutral teletext layout.
The selection made is valid for all channels which broadcast teletext.
Note: It may take a few seconds before teletext broadcast switches over to
Teletext level 2.5.
Set/Change code
The Child lock feature (see TV, Features, p. 18) allows you to lock channels to
prevent children from watching certain programmes.
To watch locked channels, you need to enter an access code.
The Set/Change code menu item allows you to create or change a Personal
Identification Number (PIN).
&
Select Set / Change code with the cursor down.
é
If no code exists yet, the menu item is set to Set code . Follow the
instructions on screen.
If a code has previously been entered, the menu item is set to
Change code .
Follow the instructions on screen.
All number combinations from 0000 to 9999 are valid numbers.
“
The General menu reappears with a message confirming that the code has
been created.
Important:You have forgotten your code !
&
Select Set/Change code in the General menu.
é
Press OK.
“
Press the cursor right.
‘
Enter the overriding code 8-8-8-8.
(
Press the cursor again and enter a new personal 4-digit code.
The previous code is erased and the new code is stored.
Centre mode
When you have connected a multi channel audio receiver to the receiver box
(see Connect peripheral equipment, p. 30) and you have selected
Centre
mode Yes , the loudspeakers of the monitor will act as centre speaker, making
a separate centre speaker unnecessary.
General
Programme title
Setup
Yes / No
General
Teletext level 2.5
Setup
On / Off
Yes / No
General
Set/Change code
Setup
General
Centre mode
Setup
1008.3 gb /69 08-07-2002 14:20 Pagina 10