Panasonic CQ-VD6503N - Manual (Page 39)

38
39 CQ-VD6503N
English
: disables the test tone
: enables the test tone
default:
¡ When the test tone is set to on, test signal (a continu-
ous tone) is output from each speaker for approximately
2 seconds.
Adjust the output balance so that the tone appears to
have the same volume from each speaker.
Adjusting the output balance:
Adjust the volume of all of the other speakers to the vol-
ume level of the speaker from which the test signal
appears to be the quietest.
OFF
ON
OFF
(Test tone output) TEST TONE
Note:
¡
While the private
mode is active, only
and
can be
adjusted.
FRONT R
FRONT L
CROSS OVER
Cut off frequency
: down, : up
Setting range: 63 Hz to 200 Hz
default: 100 Hz
: down, : up
Setting range: off, 63 Hz to 200 Hz
default: off
Note:
¡
This setting is not available if is set to .
¡ is enabled only on the front speakers
(R/L) and rear speakers (L/R).
HPF CUT OFF
ON CS Auto
[ ]
(High Pass Filter) HPF CUT OFF
[ ]
(Sub-woofer Low Pass Filter) LPF CUT OFF
TIME ALIGNMENT
(Delay time setting of each speaker)
Adjusting the timing with which the audio from each
speaker reaches the listener’s position
: down, : up
Setting range: 0 ms to 5 ms (1 ms steps)
1 ms = 0.001 seconds
default: 0 ms
: down, : up
Setting range: 0 ms to 15 ms (1 ms steps)
1 ms = 0.001 seconds
default: 0 ms
¡ Make this adjustment while listening to sound.
¡ If the speaker setting is for a speaker, that
speaker cannot be selected.
¡ When “PRO LOGIC” is displayed, 15 ms are automatically
added to the delay time setting for the surround speakers.
NONE
[ ]
(Surround speaker delay time
setting)
SUR
[ ]
(Centre speaker delay time set-
ting)
CENTER
SOURCE LEVEL
Setting the AV1/AV2 input level
Make this setting if it is not possible to adjust the volume
through the connected device (on the output side).
: sets the level low/sound volume increases
: sets the level high/sound volume decreases
default:
: sets the level low/sound volume increases
: sets the level high/sound volume decreases
Note:
¡
If the input level from AV1/AV2 is too high, the audio
will not be output normally.
¡ After setting the input level
The volume can be adjusted by pressing [+] or [–]
(VOL) on the remote control or turning rotary volume
controller on the unit.
default: HIGH
HIGH
LOW
(Setting for AV2) AV2 LEVEL
HIGH
HIGH
LOW
(Setting for AV1) AV1 LEVEL