Panasonic CQ-VD6503N - Manual (Page 91)

14
15 CQ-VD6503N
English
Car Navigation System
Preparation:
¡
Connect the Car Navigation System.
¡ Specify the correct terminal that is connected to the car navigation system in the . ( a page 20) NAVI INPUT
Press [NAVI] to change to the car naviga-
tion mode.
Press [NAVI] again to cancel.
To switch Operation Screen ON, press [ENTER] on the
remote control.
Car Navigation Mode Selection
Note:
¡
If the navigation mode is ON, only the audio signal is
switched while the video signal remains as it is.
¡ The volume of the voice guidance from the car naviga-
tion system can be set. (
a page 20)
¡ Press [NAVI] after making sure that the power button
on the main unit is set to on. Pressing [NAVI] allows
the navigation mode to be activated even if the power
button of the main unit is set to off, but operations may
be different from those in other modes in this case.
¡ The position adjustment of navigation screen shall be
performed at the navigation unit side.
Connecting with Panasonic Car Navigation System
(e.g. CN-DV2300N, option)
Connect a Panasonic car navigation system to RGB
connector.
ASPECT
MUTE
TA
NAVI
TUNE
FOLDER
ALBUM
TRACK
SRC
VOL
ASP
P-MODE
PWR
TILT
CQ-VD6503N
NAVI
[NAVI]