Philips HTS8141/12 - Manual (Page 22)

22 EN
Turn on Progressive Scan
If you connect this unit to TV with the
component video connection (see chapter
‘Connect video cables - Option 3: Connect to
component video jack’ for details), you can turn
on the progressive scan output if your TV
supports progressive scan.
1
Turn on the TV to the correct viewing
channel for this unit.
2
Press DISC MENU.
3
Press OPTIONS.
4
Press
V to select [ Video Setup ] in the
menu, then press
B.
RGB
YUV
Video Setup
Picture Settings
Advanced Picture
TV Display
TV Type
Progressive
Component Video
Closed Caption
5
Select [ Component Video ] > [ YUV ],
then press OK.
On
Off
Picture Settings
Advanced Picture
TV Display
TV Type
Progressive
Component Video
Video Setup
Closed Caption
6
Select [ Progressive ] > [ On ], then press
OK.
A warning message is displayed.
7
To proceed, select [ OK ] in the menu
and press OK.
The progressive setup is complete.
Note
If a blank/distorted screen is displayed, wait for 15 •
seconds for the auto recover.
If no picture displayed, turn off the progressive scan •
mode as follows:
1) Press
Z to open the disc compartment.
2) Press
B.
3) Press SUBTITLE.
8
To exit the menu, press OPTIONS.
9
You can now turn on the progressive scan
mode on your TV (see the TV user
manual).
Note
There are some progressive scan TVs that are •
not fully compatible with this unit, resulting in an
unnatural picture when playing back a DVD VIDEO
disc in the progressive scan mode. In such case, turn
off the progressive scan feature on this unit and your
TV.
1_hts8141_12_eng7_Final_with Dock.indd 22 8/4/2009 2:30:56 PM