Features, Switching the link alarm on and off, Connecting / disconnecting the belt clip – Philips SC468 User Manual
Page 11
EN
11
Switching the LINK alarm on and off
You can switch on the LINK alarm on the parent unit.The LINK
alarm will beep when connection between the units is lost.
1 Open the parent unit’s battery compartment (B-12) by sliding
down the cover.
2 Set the switch (B-13) inside the compartment to the ON (
)
position.
3 Slide the battery compartment cover (B-12) back in place
until it clicks in position.
• To switch off the alarm, set the switch (B-13) to the OFF (
)
position.
Connecting / disconnecting the belt clip
If the parent unit is operating on batteries, you can carry it in
and around your house, giving you freedom of movement while
still monitoring your baby.
Connecting the belt clip
• Insert the little spindle on the rear of the belt clip (B-15) into
the recess on the rear of the parent unit.
Turn the belt clip (B-15) to the left until it clicks in position.
Disconnecting the belt clip
• Turn the belt clip (B-15) to the right (TURN
2) and take it
off.
Features