Pride Mobility Jazzy 1113 - Manual (Page 23)

US Jazzy 1113/Rev I/Feb03 www.pridemobility.com 23
V . D I S A S S E M B L Y
Figure 10. Front Frame
Figure 9. Front Frame
Figure 8. Disconnect Battery Cases
6. Squeeze together the latch release levers that hang vertically
down from the crossbar at the rear of the battery well frame.
See figure 9. Lift up the rear end of the battery well frame. Pull
it to the rear of the chair to release the front slots from the
locating pins on the bottom bar of the front frame.
To disassemble the right frame assembly from the
front frame:
1. Remove the battery well frame as previously described.
2. Stand behind the Jazzy and grasp the right frame assembly
handle (located next to the front seat post tower) with your
right hand.
3. Use your left hand and thumb to hold the front frame and press
and hold (toward the center of the front frame) the silver-colored
latch release lever. See figure 10.
4. Push the right frame assembly outward (toward the right) with
your right hand holding the right frame assembly handle.
5. Pull up with your left hand on the front frame until the latching
mechanism releases.
6. Keep pulling upward with your left hand until the locating pin
on the bottom of that side of the front frame releases from its
slot in the right frame assembly.
7. Carefully let the right frame assembly tilt to a resting position.
To disassemble the left frame assembly from the front
frame:
1. Remove the battery well frame as previously described.
2. Stand behind the Jazzy and grasp the left frame assembly handle
(located next to the front seat post tower) with your left hand.
3. Use your right hand and thumb to hold the front frame and
press and hold (toward the center of the front frame) the silver-
colored latch release lever. See figure 10.
4. Push the left frame assembly outward (toward the left) with
your left hand holding the left frame assembly handle.
5. Pull up with your right hand on the front frame until the latching
mechanism releases.
6. Keep pulling upward with your right hand until the locating pin
on the bottom of that side of the front frame releases from its
slot in the left frame assembly.
7. Carefully let the left frame assembly tilt to a resting position.