Pride Mobility Jazzy 1113 - Manual (Page 25)

US Jazzy 1113/Rev I/Feb03 www.pridemobility.com 25
V I . C O M F O R T A D J U S T M E N T S
ARMREST ANGLE
You can increase or decrease the armrest angle to fit your specific needs. See figure 13.
To change the armrest angle:
1. Lift the armrest straight up so that it is perpendicular to the floor.
2. Use a 7/16-in. wrench to loosen the jam nut. See figure 13.
3. Use a 5/32-in. hex key to loosen the adjustment screw.
4. Turn the screw clockwise to lower the front of the armrest and counterclockwise to raise the front of the
armrest.
5. Lock the adjustment screw into place by tightening the jam nut.
ARMREST HEIGHT (OPTIONAL)
Your Jazzy may be equipped with height-adjustable armrests.
To change the armrest height:
1. Remove the ball detent pin from the armrest.
2. Move the armrest up or down to the desired height.
3. Align the holes and reinsert the ball detent pin.
CONTROLLER EXTENSION
The controller can easily slide out away from the armrest, or in toward the armrest.
To extend the controller:
1. Use a 3/16-in. hex wrench to loosen the setscrew. See figure 14.
2. Slide the controller mounting bracket into or out of the armrest to the desired position.
Figure 14. Underside of Armrest
LOOSEN
THIS
SETSCREW
TO ADJUST
JOYSTICK
Figure 13. Armrest Angle Adjustment
TURN THIS SCREW
TO CHANGE
ARMREST ANGLE
JAM NUT
LOCKS
ADJUSTMENT
SCREW
IN PLACE