Panasonic RQT7089-3P - Manual (Page 9)

9
RQT7089
Si
mple se
tu
p
Conserving power
The unit consumes power (approx. 0.5 W) even when it is turned
off with [
Í ]. To save power when the unit is not to be used for a
long time, unplug it from the household AC outlet.
Remember to reset the radio stations and any other memory items
before using the unit again.
Information you enter into the unit’s memory remains intact for up
to 1 week after the AC power supply cord is disconnected.
Do not;
≥ mix old and new batteries.
≥ use different types at the same time.
≥ heat or expose to flame.
≥ take apart or short circuit.
≥ attempt to recharge alkaline or manganese batteries.
≥ use batteries if the covering has been peeled off.
Mishandling of batteries can cause electrolyte leakage which
can damage items the fluid contacts and may cause a fire.
Remove if the remote control is not going to be used for a long
period of time. Store in a cool, dark place.
∫ Use
Aim at the sensor, avoiding obstacles, at a maximum range of
7 m (23 feet) directly in front of the unit.
STEP
4
Antennas and AC power supply cord
FM ANT AM ANT
AC IN~
LOOP ANT
HOLDER
LOOP EXT 75 GND
1
2
1
2
3
Fix the other end of the antenna
where reception is best.
AM loop antenna
Keep loose antenna cord away from
other wires and cords.
Turn the antenna to the
angle of best reception
and least interference
To household
AC outlet
FM indoor antenna
AC power supply cord
(included)
To attach to a wall or other surface
Screw
(included)
AM loop antenna
holder (included)
Adhesive tape
AM loop antenna set AC power supply cord FM indoor antenna
Plug in the AC power supply cord after
making all connections.
STEP
5
The remote control
R6/LR6, AA, UM-3
1
2
3
3
+
-
+ -
Remote control Batteries
≥ Insert so the poles ( i and
j ) match those in the
remote control.
≥ Do not use rechargeable
type batteries.
7089en.book 9 ページ ２００３年４月２８日 月曜日 午前９時２８分