Printronix ThermaLine T5000r - Manual (Page 67)

Advanced Validator Options
67
Profile H Mag
This menu item selects the horizontal magnification for printing the
scan profile. This allows you to zoom in on the profile. Magnification
values are multiples of the scan profile length printed for a given
Beam Width setting. For example, if the Beam Width setting of
1800 prints a 4 inch scan profile, a Profile H Mag setting of 2 prints
an 8 inch scan profile.
You can set the Profile H Mag parameter to a value from 1 to 4.
The default is 1.
1. Press to take the printer offline and place the printer in
Menu mode.
2. If necessary, press ↓ and
↵
at the same time to unlock the
↵
key.
3. If necessary, press until VALIDATOR displays.
4. Press ↑ until Profile H Mag displays.
5. Press + or – to scroll through the values: 1 to 4. The default is 1.
6. Press
↵
to select the desired value.
7. Press
↓
and
↵
at the same time to lock the
↵
key, then press
PAUSE to take the printer offline.
8. Press PAUSE again to put the printer online.
Figure 18 shows a Profile H Mag setting of 2 for the same scan
profile shown in Figure 17, page 66 (Profile H Mag setting of 1).
Figure 18. Sample Scan Profile: Profile H Mag = 2
..
.
..
.