Printronix ThermaLine T5000r - Manual (Page 97)

97
A
Adjusting the scanning beam, 27, 33
Auto detect bar codes, 50, 78
Auto Report, 45
Auto Report Time, 46
Average BWD, 49
B
Bad bar codes, 78
Bar Code Demo Page, 36
Bar code fails / Job has errors, 86
Bar code failure, 78
Bar code grading, 57
Bar Code Improper / Data Format, 86
Bar code quiet / zone too small, 87
Bar codes supported, 11
Bar width deviation, 49, 55
Beam adjustment, 27
Beam Shift, 72
Beam shifting, 33
Beam Width, 71
BWD, 49
C
Calibration / warning, 87
Calibration, setting, 34
Checksum Failure, 87
Clear Data, 47
Clear validator data, 47
Configuring, 44
Contact information, 95
Contrast too low / Check media, 88
Customer Support Center, 95
D
Decodeability, 55
Defects, 56
Demo Page, 36
Disabling validator, 44
E
EC Min, 59
Enabling the validator, 26
Enabling validator, 45
Error action, 79
Grade&Report, 83
Overstrike Mode, 81
Rescan Form, 83
Rescan&Retry, 84
Rescan&Stop, 84
Retry Form, 82
Stop Mode, 81
Stop & Retry, 82
Error messages, 86
Bar code fails / Job has errors, 86
Bar Code Improper / Data Format, 86
Bar code quiet / zone too small, 87
Calibration / warning, 87
Checksum Failure, 87
Index