Pentair 710 - Manual (Page 11)

7
Prowler ™ 710 Installation and User’s Guide
Figure 6.
Placing the Cleaner into the Pool
WARNING —Risk of electrical shock or electrocution.
The power supply MUST be placed and a minimum distance of 10 feet away from the pool.
Failure to do so could create an electrical hazard which could result in death or serious injury to pool
or spa users, installers, or others due to electrical shock, and may also cause damage to property.
1. Place the cleaner in the pool upside down, gently tilting it side to side to allow any trapped air to escape.
Once the air is removed, turn the cleaner right side up and allow it to sink to the bottom of the pool with the
wheels down. See Figure 5.
NOTE: Your cleaner must be completely submersed in the pool water before it is switched on. If the
cleaner does not sink it is because air is still trapped inside. Repeat Step 1.
2. Uncoil the Floating Cable that extends from the cleaner’s body and spread it over the pool water surface
as evenly as possible. If your pool is elongated (rectangular, oval, etc.), place the Floating Cable at the middle
of the pool's length to allow adequate cable length to reach the entire pool. Make sure that the Floating Cable
is not tangled or kinked. See Figure 6.
3. Plug your cleaner's Floating Cable into the Power Supply, see Figure 7. Be sure that the Power Supply
ON/OFF Switch is in the “OFF” position.
Figure 5.
(Remember to keep the Power Supply at least 10 feet away from the pool.)