Pentair 710 - Manual (Page 14)

10
Prowler ™ 710 Installation and User’s Guide
Cleaning or Changing the Filter Bag
1. Make sure that the Power Supply is turned
“OFF” and that the cleaner's Floating Cable
is unplugged from the Power Supply. Place
the cleaner on its back on a non-abrasive
surface and release the two Lock Tabs,
(located on the sides of the unit), see
Figure 11. Using your thumbs, push the
Lock Tabs away from the center of the
cleaner to unlock the Bottom Lid
Assembly one Lock Tab at a time, see
Figure 12. Remove the Bottom Lid
Assembly, see Figure 13.
NOTE: Rest you cleaner on a non-
abrasive surface (i.e. towel, doormat,
etc.) to avoid scuffing and scratching
your cleaner.
2. Remove the Filter Bag from the bag support
Wire Frames, see Figure 14. Turn the
Filter Bag inside out, (the Fine Filter Bag
has a soft felt surface on the inside), and
wash off visible dirt using high pressure
with a garden hose, or a faucet. Gently
agitate the Bag in your hands to help
remove fine particles. Continue wringing,
cleaning and squeezing the Bag gently
until rinse water is clear. Use of a
washing machine, (cold water only), is
recommended when visible dirt will not
rinse off by other methods. DO NOT USE
DETERGENT or BLEACH! DO NOT
MACHINE DRY!
3. Turn the Filter Bag “right side out”, (felt
surface on the inside), re-mount the Bag on
the Wire Frames making sure that the
Label on the Bag is centered on one of the
long sides of the Bottom Lid Assembly, directly between the two U’s in the Wire Frames, see Figure 16.
Pull the Bag toward the middle of each Wire Frame so that the Bag corners are snug against the corners of
the Wire Frame. Tuck the excess Bag into the U-shaped section of the Wire Frames as shown in Figure 16.
4. Re-install the Bottom Lid Assembly. Make sure that neither debris nor the Filter Bag itself interferes with
complete closure of the Bottom Lid Assembly. A locking sound from each Lock Tab will be heard when
locked properly!
Lock Tabs
Intake Valve Flaps
Bottom Lid Assy.
Bottom Lid Assy. Filter Bag
Label
Wire Frames
Long Side
Short Side
Figure 11. Figure 12.
Figure 13. Figure 14.
Figure 15. Figure 16.