Panasonic CAMERA MANAGEMENT SYSTEM BB-HGW700A - Manual (Page 27)

27 [For assistance, please call: 1-800-272-7033]
Installation/Troubleshooting
Setup Pages Display
Problem Cause and Remedy
The Top Page or Setup
Page is not displayed. • Dialog boxes may not be displayed immediately due to the state
of the LAN.
• Check that one of LAN1 - LAN4 or WIRELESS indicators are
shining green. Also, check if the LAN card or wireless LAN card
is on. If not, check that the LAN is connected.
• Check that the power supply was turned on in the following order:
modem, this product, PC connected to the LAN side.
• Check that an IP address has been assigned to the LAN side PC
by this product (see page 123 of Operating Instructions on the
CD-ROM). If it has not been assigned, check that the PC has
been set to Obtain IP Address Automatically, and restart the PC.
• If this product's IP address has been modified (see page 74 of
Operating Instructions on the CD-ROM), enter the new IP
address in the web browser's address bar. (The default port
number is 8080.)
• To access the setup page, it may be necessary to set the web
browser. (see page 122 of Operating Instructions on the CD-
ROM)
• JavaScript is used on the setup page. If JavaScript is disabled in
the web browser settings, enable it and then access the setup
page.
1
Select Internet Explorer Tools, then Internet Options... in
Internet Explorer, and click the Security tab.
2 Click Custom Level... in Security level for this zone.
3 Enable "Active scripting" in Settings.