Pioneer DVH-P4100UB - Manual (Page 44)

Notes
! Up to 42 characters can be displayed on one
line. If more than 42 characters are set, the
line breaks and the characters are displayed
on the next line.
! Up to 126 characters can be displayed on one
screen. If more than 126 characters are set,
the excess characters will not be displayed.
Setting for digital output
Audio which is outputted from digital output
of this unit can be selected. Normally, set to
STREAM. If this unit
’s digital output is not
used, there is no need to change settings.
! Selecting Linear PCM enables you to
switch the output channel if playing the fol-
lowing type of discs. (Refer to Selecting
audio output on page 28.)
— Dual mono mode DVD video discs
— Bilingual DVD-VR discs
1 Move the thumb pad up or down to se-
lect IEC DIGITAL OUTPUT in GEN.
2 Click the thumb pad to select the de-
sired digital output setting.
! STREAM – The Dolby Digital/DTS signal is
output as it is (initial setting)
! Linear PCM – The Dolby Digital/DTS signal
is converted to and output as a linear PCM
signal
# Pressing RETURN takes you back to the pre-
vious display.
Displaying your DivX ® VOD
registration code
In order to play DivX VOD (video on demand)
content on this unit, you first need to register
the unit with your DivX VOD content provider.
You do this by generating a DivX VOD registra-
tion code, which you submit to your provider.
1 Move the thumb pad up or down to se-
lect DivX VOD in GEN.
2 Click the thumb pad.
Your 8-digit registration code is displayed.
! Make a note of the code as you will need it
when you register with a DivX VOD provider.
# Pressing RETURN takes you back to the pre-
vious display.
Setting the down sampling output
If the sampling frequency of the audio is more
than 96 kHz, the audio outputted from the digi-
tal output of this unit can be reduced to 48
kHz. Normally, set the down sampling output
to on. If this unit
’s digital output is not used,
there is no need to change settings.
1 Move the thumb pad up or down to se-
lect SAMPLING OUTPUT in GEN.
2 Click the thumb pad.
Each time you click the thumb pad the se-
lected setting switches on or off.
# Pressing RETURN takes you back to the pre-
vious display.
Operating this unit
En
44
Section
02