Philips LX700 - Manual (Page 14)

14
English
Tuning to radio stations
– In TUNER mode, press S or T briefly and
repeatedly until the right frequency or optimum reception is
obtained.
–
Press S or T more than 1 second if you want to
activate automatic search tuning. Tuning automatically stops
when a station of sufficient strength has been found.
–
Press TUNER again to select the desired band : FM or
MW.
Presetting radio stations
You can preset up to 40 stations .
1 Tune to your desired radio station by pressing the S or
T button on the front panel or on the remote control.
and press PROGRAM to enter the program mode.
➜ “
PXX : XX.XX” is displayed.
2 Use the numeric keypad (0-9) or 1 / 2 to select the
desired preset number (01~40).
3 Press PROGRAM to store the station.
Sleep timer setting
The sleep timer enables the system to switch to standby
mode automatically at a preset time.
1 On the remote control, press SLEEP repeatedly to select a
preset time.
➜ The selections are as follows (time in minutes):
15 ™ 30 ™ 45 ™ 60 ™ 90 ™ 120™ OFF ™ 15...
2 When you reach the desired length of time, stop pressing
the SLEEP button.
➜ “SLEEP” appears.
To check the remaining length of time after sleep
timer is activated:
● Press SLEEP.
To change the preset sleep timer
● Press SLEEP again while the remaining sleep timer is
shown.
➜ The display will show the next sleep timer options.
To deactivate the sleep timer
● Press SLEEP repeatedly until “ OFF” is displayed, or press
STANDBY ON.
Others Functions
O THERS F UNTIONS
Night Mode Function
When very dynamic movie soundtracks are played at low
volume, such as late at night, you can use Night Mode to
apply appropriate compression so that low-level program
content is not lost and high volume effects are restrained.
● On the remote control, press NIGHT. “NIGHT ON”
appears briefly when activated.
● Press NIGHT again to deactivate. “NIGHT OFF”
appears briefly.
Notes:
–
This function only works when Dolby Digital is
selected.