Panasonic AW-E560 - Manual (Page 23)

-21-
• The kit WV-CA28T10 has the following two cables in it.
• 20P-BNC cable CA20TBNC
• Pan/Tilt control cable CA28T103
• Connect the camera AW-E560 to the remote control box WV-CB550 with the CA20TBNC coaxial cable.
• Connect the camera AW-E560 to the receiver WV-RC100 with the CA28T103 cable according to the cable connecting instruc-
tions.
• Connect the camera AW-E560 to the remote control box WV-CB550 with two coaxial cables (video signal and G/L signal).
(PSF 1/2M, maximum total length 300 m)
• Use Model AW-E560 for camera. In case of using a pan/tilt head, the receiver WV-RC100 and the pan/tilt head control cable
are necessary. Be sure to use a pan/tilt head of contact type (WV-7230D or WV-7225, for example).
• For a detailed description of connecting each device, refer to its instruction manual.
• The devices should be switched on only after their connection.
■ CONNECTION PROCEDURES FOR CABLE KIT WV-CA28T10
ZOOM/FOCUS
REMOTE
EXT DC IN
PAGE ITEM
(AWC)
UP
(ABC)
DOWN
(BAR)
IRIS
SEE MANUAL
CAUTION
CONNECT TO SPECIFIED
CLASS 2 POWER SUPPLY
ONLY SEE MANUAL
VBS/HD
75 Ω VD
VIDEO/RGB
CONTROL
VIDEO OUT G/L IN
ON
OFF
CAMERA VIDEO
G/L VIDEO
G/L VIDEO
MONITOR VIDEO
CONTROL SIGNAL
20-pin BNC CableCA20TBNC)
PAN/TILT CONTROL
20-pin Connector
WV-CB550
DC12V Camera AWE560
Remote Control
Box