Panasonic AW-E560 - Manual (Page 31)

-29-
■ GEN-LOCK ADJUSTMENT
Phase adjustments must be performed with the camera or
the RCU (RCB) when external synchronizing signals are
supplied to the system in cases where multiple cameras
are used or peripheral devices are connected.
■ HORIZONTAL PHASE CONTROL
Observe the waveform of the external synchronizing input
signal (black burst signal) and video output signal on a
two-channel oscilloscope. Then match the horizontal
phase of both signals by adjusting them with the cameras
or RCU's horizontal phase control.
[ADJUSTMENT by CAMERA]
1. Press the BAR (DOWN) switch for over 1 second to
display the color bar.
2. Select page No.4 of INITIAL SET menu.
3. Select “H PHASE” with the item switch.
4. Adjust the horizontal phase with the Up switch and
Down switch.
NO.4 ** INITIAL **
H PHASE +....I....-
SC COARSE 0°
SC FINE +....I....-
RET END
PAGE ITEM UP DOWN
COARSE FINE
SC PHASE
270
180 90
0
H.PHASE
USER SET
OFF ENC
VF ON
Horizontal phase
control
Subcarrier phase
coarse control
Subcarrier phase
fine control
External gen-lock input signal
(black burst output of special
effect generator)
Video signal
[ADJUSTMENT WITH RCU (RCB)]
Use the horizontal phase control located in the pocket of
RCU (RCB).