Panasonic AW-E560 - Manual (Page 55)

■ How to Set
(1) Select the date and time positions to change, or a
command, using the item switch.
(2) To change time/date, use the Up switch.
The set value increases each time the Up switch is
pressed. Stop pressing it when the desired figure
appears.
(If the Up switch is kept depressed, the figure increas-
es rapidly.)
(3) If the page switch is pressed when the cursor is at
POSI, time/date display position is ready to be set.
(4) To return to the INITIAL SET menu screen, move the
cursor to RET, and press the page switch.
(5) To return to the normal state, do the following steps.
If the camera is used alone, move the cursor to END,
and press the page switch.
If the camera is used with an RCU (RCB), set the user
set switch to OFF.
■ Time/Date Display Position
Time/date display position can be set as desired.
■ Time/Date Display Position Setting
(1) Set time/date.
(2) Move the cursor to POSI, and press the page switch.
Time/date display position is ready to be set, and its
screen appears on the monitor.
Time/date display position can be set at the camera
head or RCU (RCB).
-53-
AW-E560
02-23-93
18:40
Camera ID display
position
Time/date display
(blinking)
It cannot be over time/
date display.
■ Time/Date Display Position Set Screen
■ How to Set
(1) Move the set time/date display position using the item
switch, Up switch, or Down switch.
Item switch:
To move the cursor 1 line down
Up switch: To move the cursor 1 position left
Down switch: To move the cursor 1 position right
UP SW ← → DOWN SW
↓
ITEM SW