Polycom 500D - Manual (Page 12)

SoundStation Premier
Installation Instructions and User's Guide
6
If the system is not already on,
press
ON/OFF and dial the number.
The console display will go blank,
then show each number as it is being
dialed. (Remember, depending on your
PBX, you may need a special dialing
prefix to access outside lines.)
Once the call is connected, a timer will
appear on the display showing how long
the call has been in process.
When you are ready to end a call,
press
ON/OFF again.
When the phone is on and a dial
tone is heard, adjustment of the dial
tone volume can be made by pressing
VOL or VOL .
The display will show: TONE VOL.
After 5 seconds, the display will revert
to its previous mode.
Once a call is connected, the speaker
volume can be made louder by pressing
VOL or softer by pressing
VOL . The display will show SPKR
VOL. After 5 seconds, the display will
revert to its previous mode.
There are 32 volume levels—stored
independently in the system’s
memory—for both dial tone
and speaker volume.
VOL
RINGER VOL
HOLD
TRANSFER
THIS PHONE #
ON/OFF
B
A
C E D F
N
M
O K J L H
G I
U T V PQ
RS
W
XYZ
REDIAL
CONF MUTE
SHIFT
VOL
RINGER VOL
HOLD THIS PHONE #
ON/OFF
B
A
C E
D F
N
M
O K J L H
G I
U T V PQ
RS
W
XYZ
REDIAL
CONF MUTE
SHIFT
TRANSFER
Using the SoundStation Premier 500D/550D System
To Answer a Call
Press ON/OFF when you hear
the SoundStation Premier 500D/550D
Console’s tone.
To Adjust Tone Volume and Speaker Volume
To place a phone call on HOLD at any
time, press SHIFT then press MUTE .
This shuts off the speaker and all
microphones. The display will show
HOLD and all LEDs will begin
blinking red.
To take the call off HOLD,
press the
MUTE key again.
To Place the Call On Hold
VOL
RINGER VOL
HOLD THIS PHONE #
ON/OFF
B A
C E D F
N
M
O K J L H
G I
U T V PQ
RS
W
XYZ
REDIAL
CONF MUTE
SHIFT
TRANSFER
To Place a Phone Call