Philips LX3600 - Manual (Page 19)

19
English
3139 115 22851
Step 1: Inserting batteries
into the remote
control
1
3
2
1
Open the battery compartment.
2
Insert two batteries type R06 or AA,
following the indications (+-) inside
the compartment.
3
Close the cover.
Using the remote control to operate
the system
1
Aim the remote control
directly at the remote
sensor (iR) on the front
panel.
2
Select the source you wish
to control by pressing one
of the source select
buttons on the remote
control (for example
TV, TUNER).
3
Then select the desired
function (for example
ÉÅ, S, T ).
CAUTION!
–
Remove batteries if they are
exhausted or if the remote is not to
be used for a long time.
–
Do not use old and new or
different types of batteries in
combination.
–
Batteries contain chemical
substances, so they should be
disposed of properly.
Getting Started
IR
OPEN/CLOSE PLAY/PAUSE
SOURCE PREV
Step 2: Setting the TV
IMPORTANT!
Make sure you have completed all
the necessary connections. (See
page 13 “Connecting TV”).
1
Press SOURCE control until “ DISC ”
appears on the display panel (or press
DISC on the remote).
2
Turn on the TV and set to the correct
video-in channel. You should see the blue
Philips DVD background screen on the
TV.
3
Usually this channel is between the
lowest and highest channels and may be
called FRONT, A/V IN, or VIDEO. See
your TV manual for more details.
➜ Or, you may go to channel 1 on your
TV, then press the Channel down button
repeatedly until you see the Video In
channel.
➜ Or, the TV remote control may have a
button or switch that chooses different
video modes.
➜ Or, set the TV to channel 3 or 4 if you
are using an RF modulator.
001-046_LX36_17_Eng 29/08/2003, 2:45 PM 19