Philips CEM2000B - Manual (Page 11)

12
4
Remove the mounting sleeve with the
supplied disassembly tools.
5
Install the sleeve into the dashboard and
bend the tabs outward to fix the sleeve.
Note
If the unit is not fixed by sleeve but by the •
supplied screws, skip this step.
5mm 5mm 5mm 5mm
Mount into the dashboard
1
If the car does not have an on-board
drive or navigation computer, disconnect
the negative terminal of the car battery.
If you disconnect the car battery in •
a car that has an on-board drive or
navigation computer, the computer
may lose its memory.
If the car battery is not disconnected,
•
to avoid short-circuit, ensure that the
bare wires do not touch each other.
2
Ensure that car dashboard opening is
within these measurements:
3
Remove the two screws on the top of the
unit.
183 mm
53.5mm
5mm
EN