Panasonic H-37PWD7UY - Manual (Page 8)

8
Requires two AA batteries.
1. Turn the transmitter face down.
Press and slide off the battery
cover.
2. Install the batteries as shown in the
battery compartment.
(Polarity + or – must match the
markings in the compartment.)
Two "AA" size
Helpful Hint:
For frequent remote control users, replace old batteries with
Alkaline batteries for longer life.
Precaution on battery use
Incorrect installation can cause battery leakage and corrosion that will damage the remote control transmitter.
Disposal of batteries should be in an environment-friendly manner.
Observe the following precautions:
1. Batteries should always be replaced as a pair. Always use new batteries when replacing the old set.
2. Do not combine a used battery with a new one.
3. Do not mix battery types (example: “Zinc Carbon” with “Alkaline”).
4. Do not attempt to charge, short-circuit, disassemble, heat or burn used batteries.
5. Battery replacement is necessary when the remote control acts sporadically or stops operating the Plasma Display.
3. Replace the cover and slide in
reverse until the lock snaps.
PLASMA DISPLAY
INPUT
SURROUND
VOL
N R
PICTURE SOUND SET UP
ASPECT PICTURE
POS. /SIZE
OFF TIMER PC
MULTI PIP SWAP SELECT ZOOM
MOVE
Accessories
Accessories Supplied
Check that you have the Accessories and items shown
Operating
Instruction book Remote Control
Transmitter
EUR646529 Warranty
AC cord Fixing bands
Batteries for the Remote
Control Transmitter
(AA Battery
× 2)
Ferrite core
(Small size)
× 1
Ferrite core
(Large size)
× 2
Remote Control Batteries