Philips AJ 3380 - Manual (Page 4)

1 ALARM 1:
– BUZ (zer) - to activate buzzer for alarm 1
setting
– RAD (io) - to activate radio for alarm 1
setting
– OFF - to switch off alarm 1
2 ALARM 2:
– BUZ (zer) - to activate buzzer for alarm 2
setting
– RAD (io) - to activate radio for alarm 2
setting -
– OFF - to switch off alarm 2
3 RADIO - to switch radio mode ON/OFF
4 BRIGHTNESS - to adjust the display
illumination: HI-LOW
5 Display - to show the hours, minutes and
activated alarms
6 CLOCK:
– TIME SET - to adjust clock time
– ALARM 2 - to adjust/review ALARM 2
– ALARM 1 - to adjust/review ALARM 1
– RUN - to return to clock time display after
setting clock/alarm times
– 7, 4 - (fast up, slow down) - to adjust
both the hours and minutes for the clock and
alarm times
7 SLUMBER - to activate slumber time
8 ALARM RESET - to stop the active alarm
for 24 hours
9 DBB - to select an enhanced bass sound:
Dynamic Bass Boost
0 SLUMBER OFF / REPEAT ALARM
– to switch off slumber
– to stop the active alarm for a 7 minute
period
! TUNING - to tune to radio stations
@ BAND - to select FM-MW (or LW) band
# VOLUME - for adjusting the volume
$ Battery door - for power backup battery
% Pigtail aerial - for FM reception
^ Mains lead - for mains supply
1. Check if the mains voltage as shown on the
type plate on the base of the set corresponds
to your local mains supply.
2. Connect the mains plug into the wall socket.
The mains supply is now switched on and the
numbers on the display will start to flash. You
will need to set the correct time.
3. To disconnect the set from the mains
completely, withdraw the mains plug from the
wall socket.
For users in the U.K.: please follow the
instructions on page 2.
1. Set the RADIO switch to ON.
2. Select your waveband using the BAND switch.
3. Use TUNING to find your radio station.
4. Adjust the sound with the VOLUME and DBB
controls.
5. To turn off the radio, set the RADIO switch to
OFF.
To improve radio reception
– For MW (LW), the set is provided with a
built-in aerial which to function best should be
placed on a non-metallic surface e.g. wood,
plastic. Direct the MW (LW) aerial by
adjusting the position of your clock radio.
– For FM reception extend the pigtail aerial at
the back of the set completely to obtain
optimum reception.
Illumination brightness
– To change the brightness of the clock display
illumination adjust the BRIGHTNESS switch to
HI or LOW.
CLOCK
FM/MW (LW) RADIO
MAINS CONNECTION
BACK PANEL see fig. 1 TOP AND SIDE PANELS see fig. 1
CONTROLS INSTALLATION RADIO/CLOCK
4
English
XP AJ 3380/00.3 22-06-2000 12:14 Pagina 4