Panasonic CQ-VA7005W - Manual (Page 63)

10
11 CQ-VD7005W
English
AV-OUT
PRE-OUT REAR
S.W-OUT
PRE-OUT CENTER
REVERSE
PRE-OUT FRONT
CAMERA-IN
AV1-IN
AV2-IN
REMOTE-IN
Reverse Lead
When connecting the rear view camera, use
the reverse lead. (
a page 15)
Note: Use a Reverse Extension Cord !5 if needed.
Note:
¡ To prevent from damage to the unit, be sure to follow the wiring diagrams below.
¡ Be sure to fully plug in the connectors. Secure them with clamps and tapes.
¡ All other installation methods require the use of dedicated metal fittings. Consult with a qualified servicing engineer or
your dealer if other methods are required.
Video Output Terminal (AV-OUT)
Connect the rear monitor. (
a page 16)
Radio Antenna Connector (RADIO ANT IN)
RGB Connector
To the Panasonic Car Navigation System (available in future).
System-up Connector
To external devices equipped with system-up connector.
Pre-Out Connector (front)
To an external amplifier.
Pre-Out Connector (center)
To an external amplifier.
Pre-Out Connector (rear)
To an external amplifier.
Pre-Out Subwoofer connector (mono)
To an external amplifier.
Video Input Terminal (AV1-IN/AV2-IN)
Connect a VCR, camcorder, other brand’s car
navigation system, etc. (
a page 16)
Note: When an external device is connected
to the system-up connector, the audio termi-
nals, {(R)(Red), (L)(White)}, of AV2-IN are
disabled.
Remote-In Lead
(not used)
Camera Input Terminal (CAMERA-IN)
Connect a rear view camera. (
a page 15)
(R)(Red)
(L)(White)
(R)(Red)
(L)(White)
(R)(Red)
(L)(White)
(Yellow)
(R)(Red)
(L)(White)
(Yellow)
(R)(Red)
(L)(White)
(Yellow)
(Yellow)
(Brown/black stripe)
(Violet/white stripe)
(Black)
(Black)
CQ-VD7005W
(Rear)
: This book refers to connections to the Panasonic car navigation system that will come onto the market in the
future. Descriptions regarding the car navigation system are boxed with a dotted line.