Philips HDRW 720/17 - Manual (Page 43)

36
Programming recordings with the VCR
Plus+
® System
Thanks to this programming system, you no longer need to tediously
enter the date, TV channel, start and finish time. All the information
needed by the DVD recorder for programming is contained in the
PlusCode programming number. This 9-digit PlusCode number is found
in most TV listings magazine.
WARNING!
'Programming with the VCR Plus+
® system' without TV Guide On
Screen ™ data (empty 'LISTINGS' screen) is not possible.
1 Switch on the TV set. Select the channel on the DVD recorder (3
or 4).
2 Press TIMER s on the remote control.
P
The current data will appear.
a I will see some informations about the TV Guide On
Screen
™ system
b The TV Guide On Screen ™ system was not installed yet. Please refer
to the 'Set up the TV Guide On Screen ™ System' section.
3 Select 'PlusCode' using B .
4 Enter the entire PlusCode number. This number is up to 8 digits
long and can be found next to the start time of the TV program in
your TV listings magazine.
e.g.: 5-234-89 or 5 234 89
Enter 523489 for the PlusCode number.
If you make a mistake, press A . Select line 'PlusCode' using
B .
5 Confirm with OK .
a The following message appears on the screen: 'PlusCode
number wrong'
b The entered PlusCode number is incorrect. Repeat your entry or
cancel using the green function button.
P The decoded data appears after confirmation.
Changing the start/end times
- Use B or A to select the line (programmed recording) where you
want to change the times.
- Press the OK button.
- Select 'Start early by' or 'End late by' using A or B .
Enter the information in the line using the 0..9 number buttons on
the remote control.
- Confirm with OK .
This takes you back to the listing.
Setting up repeat recordings
You can choose in the row 'Frequency ' from the following settings
using the green action button:
'Once': one-time recordings
'Daily': Repeated daily recordings (Monday to Sunday).
'Weekly': Repeated weekly recordings (every week on the same day).
'Off': this will stop any future occurrences of the program from being
recorded but will keep the show in the list.
1 If all information is correct, press the OK button. The data is
stored.
2 To end, press TV GUIDE .
If one or more recordings have been programmed 'TIMER' will light up
on the display.
ENGLISH
Programming a recording (TIMER)